Technical Content

Well-tie analysis is a starting point for mapping facies and geology observed at well locations onto seismic cubes. This step is very important for any application that uses seismic and well data together, and can secure more accurate results by increasing consistency between seismic ...

Below is a case study of the ongoing work on the Monarb and Seagull reprocessing projects in the Central North Sea, with a focus on the use of legacy near field hydrophone recordings, 3D recursive MWD, wave equation deconvolution and AVO QC (In particular ...

The desire to extend all the benefits of broadband 3D data to 4D time-lapse surveys has been hampered by the requirement for repeatability between successive surveys. The use of deep-towed multi-sensor streamers in time-lapse acquisition creates challenges, as the existing baseline surveys will often ...

Amplitude attenuation and phase distortion of seismic data are byproducts of the Earth’s anelasticity (Q). These effects are exacerbated under regions of anomalously high absorption, such as shallow gas, causing uneven illumination and migration artifacts. We present a case study from the Norwegian North ...

To improve image resolution in the vicinity of the well, 3D VSP data was acquired at the Atlantis field in the Gulf of Mexico to complement the existing towed-streamer and OBN data. Two unique data challenges require special consideration and innovative techniques in order ...

We investigate the benefits of considering the effects of the Hessian matrix in the reflection FWI (RFWI) reflectivity, i.e., using least-squares RTM (LSRTM) to estimate the short-wavelength component of the model. In addition, a more efficient approach using single-iteration LSRTM, more specifically, using curvelet-domain ...

Using full-waveform inversion (FWI) to update velocity models that contain salt bodies with high velocity contrasts is challenging. It is even harder if erroneous salt geometry is part of the velocity model. Shen et al. (2017) showed a successful FWI application that corrected some ...

Imaged based Q-compensation coupled with FWI can solve for significant frequency and amplitude losses below shallow overburden absorptive geologic bodies. Applying Q-compensation to both the baseline and monitor 4D surveys improves the consistency of the 4D response, leading to more reliable placement of development ...

In previous publications, a hybrid deblending flow was proposed in which the last step of residual guided noise attenuation using the Noise to Signal Ratio (NSR) map was employed. This flow was proven to be effective and efficient for many OBS surveys. However, due ...